OPTIONAL EXTRAS - COLUMN LIFTS

Ramps

Fixed Ramp (sometimes known as a Fixed Leading Edge)

If a load is static (i.e. pallets or stillages) usually loaded on a pallet truck, it is necessary to incorporate a fixed ramp to facilitate easy access onto the platform, avoiding manual lifting of the load.

Hinged Ramp to Form a Stop

If a load is mobile (i.e. roll cages or containers on wheels), not only is easy access to the platform necessary but also stability of the load whilst on the platform.  Hinged ramps to form a Stop form a ramp for access and when locked in the “up” position, form a physical stop to prevent the load rolling off.

Hinged Side Ramps

Similar to hinged Ramp to Form a Stop but mounted on the side of the platform, used for kerbside loading and to prevent the load rolling off the side of the platform where steep cambers occur in the road.

Hook in Ramps

Detachable for occasional use.  Usually on the side of the platform, when needed for kerbside loading.  Must be detached from platform when in transit.

Safety Gates

Mainly used on double-tier applications.  However, sometimes incorporated for operator safety and load security when awkward loads are being handled.  Provision can be made on side and/or rear of platform.

Pendant Switch and Wanderlead Controls

Supplied as standard on most cantilevers and Tuk-a-Ways, but a very useful addition on all model types when it is necessary to ride on the platform with the load.

Lockable Control Box

Adds additional security to the tail lift against misuse.  Also gives additional protection against adverse weather conditions.  May be used to house the wanderlead socket.

Bridge Plates

Generally required on overhead beam column lifts to bridge the gap between vehicle floor and platform surface where doors are fitted.  The spring-mounted bridge plate is mounted inside the vehicle and manually operated.  The automatic bridge plate is mounted externally on the platform.